LAMBDA BOOSTER
Improves HP and TORQUE
Improves Acceleration Higher Top Speed
Easy installation
ADVANTAGES AND OPERATION OF LAMBDA BOOSTER
The Lamda Booster. "helps" the ECU to modify the A/F Ratio in the entire RPM Band.
This over mapping leads to richer mixture, better performance and with less throttle we have the same HP and Acceleration.
The gains sometimes up to 20HP and 20% better Acceleration in High performance cars and up to 10% HP increase on other cars.
The ECU is "cheated" every microsecond by the Lamda Booster and the wrong signal delivered to ECU has as a result more HP, ACCELERATION AND TORQUE in the entire RPM Band!
INSTALLATION IMPORTANT NOTES:
1. Make sure your Oxygen Sensor works properly.
2. Check and find the Correct Signal wire of the Oxygen Sensor.
3. Make sure the arrow of the L.B. is pointing the right direction.
4. Weld all connections with Hydrochloric Acid or use good terminals.
5. Cover connections with the Insulating tubes.
6. We recommend to have an ON/OFF Switch.
NOTE: In models where more than one Oxygen sensor is working, the chip must be connected to the rear sensor (from rear of the vehicle).
This device may not be used to violate the privacy rights of others. In no way will Spy Chest Inc or its subsidiaries or partners be held responsible for inappropriate use of these products.
IT IS THE SOLE RESPONSIBILITY OF THE BUYER TO CONSULT LEGAL COUNSEL FOR THE INTERPRETATION OF ANY LAWS APPLICABLE TO THE AREA OF INTENDED USE OF THESE PRODUCTS.
No posts found
